Press…

1. The upper push-button to start.

2. Press the upper push-button to read the first time.

3. Press the upper push-button to restart the chronograph.

4. Press the upper push-button to read the additional time (repeat these two steps as many time as you wish).

5. Press the lower push-button to reset.

Important:

When replacing the battery, be careful not to damage the (+) terminal which is on the side. The (-) terminal is at the bottom.

Using the adjustment ring

For setting the start time and duration of an activity. Line up the marker on the adjustment ring with the minute hand. Timing starts at the time indicated by the marker. The elapsed time is indicated by the minute hand pointing the number on the adjustement ring.

IMPORTANT: After being submerged in salt water, the Scuba 200 Chrono should always be rinsed with fresh water.

CAUTION: The Irony Scuba 200 Chrono is not a professional diving watch.

Adjusting the chronograph (e.g.: after battery change or a hard shock)

1. Pull the crown to position B.

2. Press the upper button to reach the position 12h00 with the hand of the 1/10 sec. counter.

3. Pull the lower button to reach the position 12h00 with the hand of the seconds.

4. Pull the crown to the position C.

5. Press the upper button to reach the position 12h00 with the hand of the minutes counters.

6. Press the crown to position A.

To set the date, pull the crown out to position B, and turn anticlockwise. To set the day, turn the crown in a clockwise direction. After resetting has been completed, press the crown back to position A.

A: Normal position of the crown

C: Position for setting the time

To set the time, pull the crown out to position C and turn clockwise or anticlockwise. After resetting has been completed, press the crown back to position A.

Press…

1. The upper push-button to start the chronograph.

2. The lower push-button to read the intermediary time.

3. Once again to continue (repeat the last two actions as many times as you wish to read the intermediary time while the chrono carries on).

4. The upper push-button to stop finally.

5. The lower push-button to reset.

Measure the speed Base 100 or 1000 m.

Press...

1. The upper push-button when an action starts.

2. Once again to stop after a distance of 100 or 1000 m. Read the speed indicated by the 60 seconds counter (Retrograde: 30 sec.) on the tachymeter scale (km/h = kph).

3. The lower push-button to reset.

Press…

1. The upper push-button to start the chronograph.

2. Once again to read the elapsed time.

3. The lower push-button to reset.